Geratherm Early Pregnancy Test

The Geratherm Early Detect Pregnancy Test can be used up to four days before the day your period is due, calculated 15 days after ovulation. The test utilises a combination of antibodies including a monoclonal hCG antibody to selectively detect elevated levels of hCG. The assay is conducted by urinating on the absorbent tip or immersing the absorbent tip in urine for approximately 10 seconds and obtaining the result from the coloured lines after approximately 3 minutes. The Geratherm Early Detect Pregnancy Test is a rapid test for home use and is secure as it is more than 99% accurate. It can be used at any time of the day and has an extra-large test zone and a hygienic holder, as well as an easy-to-read test result. This test detects hCG in urine at a concentration of 10 IU/ltr.

Benefits and Features

• 99% accurate
• Result obtained in 3 minutes
• Can be used at any time of the day
• Easy-to-read results

How to use?

• Remove the midstream test from the foil pouch and familiarise yourself with the product.
• Remove the cap and place it over the thumb grip.
• Hold the test by the capped thumb grip with the exposed absorbent tip pointing downward directly into your urine stream for at least 10 seconds until it is thoroughly wet.
• Note: Do not urinate on the test and control windows.
• If you prefer, you can urinate into a clean and dry container, then dip only the absorbent tip of the test into the urine for at least 10 seconds.
• After removing the test from your urine, immediately replace the cap over the absorbent tip, lay the test on a flat surface with the test and control windows facing upwards, and then begin timing.
• As the test begins to work, you may notice a light coloured flow moving across the test and control windows.
• Read the result at 3 minutes.
• If no coloured line appears, wait one minute longer.
• Some positive results may be observed in 1 minute or less depending on the concentration of hCG.
• Do not read the result after 10 minutes.